Reading: Successfully estimating tensile strength by small punch testing

Download

A- A+
Alt. Display

Conference Paper

Successfully estimating tensile strength by small punch testing

Authors:

S. Holmström ,

European Commission, Joint Research Centre, Petten, The Netherlands
X close

I. Simonovski,

European Commission, Joint Research Centre, Petten, The Netherlands
X close

D. Baraldi,

European Commission, Joint Research Centre, Petten, The Netherlands
X close

M. Bruchhausen,

European Commission, Joint Research Centre, Petten, The Netherlands
X close

E. Altstadt,

Helmholtz-Zentrum Dresden-Rossendorf (HZDR), Dresden, Germany
X close

R. Delville

SCK·CEN Belgian Nuclear Research Centre, Mol, Belgium
X close

Abstract

The Small Punch (SP) test is a relatively simple test well suited for material ranking and material property estimation in situations where standard testing is not possible or considered too material consuming. The material tensile properties, e.g. the ultimate tensile strength (UTS) and the proof strength are usually linearly correlated to the force-deflection behaviour of a SP test. However, if the test samples and test set-up dimensions are not according to standardized dimensions or the material ductility does not allow the SP sample to deform to the pre-defined displacements used in these correlations, the standard formulations can naturally not be used. Also, in cases where no supporting UTS data is available the applied correlation factors cannot be verified. In this paper a formulation is proposed that enables the estimation of UTS without supporting uniaxial tensile strength data for a range of materials, both for standard type and for curved (tube section) samples. The proposed equation was originally developed for estimating the equivalent stress in small punch creep but is also found to robustly estimate the UTS of several ductile ferritic, ferritic/martensitic and austenitic steels. It is also shown that the methodology can be further applied on non-standard test samples and test set-ups and to estimate the properties of less ductile materials such as 46% cold worked 15-15Ti cladding steel tubes. In the case of curved samples the UTS estimates have to be corrected for curvature to match the corresponding flat specimen behaviour. The geometrical correction factors are dependent on tube diameters and wall thicknesses and were determined by finite element simulations. The outcome of the testing and simulation work shows that the UTS can be robustly estimated both for flat samples as well as for thin walled tube samples. The usability of the SP testing and assessment method for estimating tensile strength of engineering steels in general and for nuclear claddings in specific has been verified.

How to Cite: Holmström, S., Simonovski, I., Baraldi, D., Bruchhausen, M., Altstadt, E. and Delville, R., 2018. Successfully estimating tensile strength by small punch testing. Ubiquity Proceedings, 1(S1), p.22. DOI: http://doi.org/10.5334/uproc.22
7
Views
6
Downloads
Published on 10 Sep 2018.
Peer Reviewed

Downloads

  • PDF (EN)

    comments powered by Disqus